Windows 10: Trying to Reset My ASUS Laptop

I am currently having a problem with factory resetting my ASUS laptop, where after I have reset the PC, it will show up the same "Choose an option" screen, where selecting any option does not do anything but loop the whole entire process. The picture shows the screen the laptop keeps resulting in. Is there any way I can fix this issue? I do have a USB thumb drive that has a recovery point that is inputted into the laptop, but it seems that it might not be working correctly.

:)

 

Unable To Connect Boase Headphones To ASUS Laptop.

Hi Chris,



Thank you for writing to Microsoft Community Forums.



In order to get clarity on this issue and assist you with appropriate troubleshooting steps, please reply with the answers to the questions below.

1. What is the model number of the Bose headphone?
   
2. How are you trying to connect the headphones to the laptop?
   
3. What is the model number of your ASUS laptop?
   
4. Are you using a wired or a wireless Bose headphone?
   

I suggest you to follow the steps mentioned in Connecting To A Computer
and try connecting your headphones to the laptop.



If you are still facing issues connecting the headphones to the laptop, I suggest you to elaborate on the issue, so that we can understand the concern and reply to us to help you further.

 

Asus Laptop Freezes Factory Reset

So I'm trying to Factory Reset my Asus laptop and while it prepares for a total reset it freezes and I've tried restarting the laptop and trying again but it freezes this is on Windows 10

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".