Windows 10: Command Console Redirection

I need to run an command line application, ffmpeg, and direct the terminal session to a log file while simultaneously monitoring its progress.


ffmpeg asks questions that I have to see to answer. It then 'takes off' processing video. While processing, it's output is 1000s of lines that I have to review at the end of run. Scrolling back to see the run is out of the question because the output is 1000s of lines -- far too many lines for the terminal window. Saving those 1000s of lines to a log file is the only alternative. But when I try redirection, I lose the ability to interact with it and monitor its progress.


I've tried many, many combinations of redirection. I've tried powershell with 'tee' and 'Tee-Object'. Nothing works.


Any ideas are welcome.


Thanks, and Stay Safe and Healthy,

Mark.

:)

 

Is there any Command line option to create job in Windows Assessment Console ?

Hi,

Thank you for posting your concern. Based on the information that you provided, you are trying to get a command for Windows Assessment Console. With this concern, we suggest you to head over this

link for the available Command-line Syntax in Assessment platform. For more information, you can visit this

link about Windows Assessment Console step-by-step guide.

Let us know how it goes.

 

GPU-Z what command line parameter ?

Suggestion: /? (-?) and /help (-help) command-line arguments to show a list of all possible arguments in a small window. *Smile

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".