Windows 10: Want to do a clean re-install. Is the "Reset this PC" good enough option?

Title says it all. Wanna do a clean re-install. Been a while since I did a clean re-install. Kind of don't want to deal with all the drivers etc. Is that option good enough?

submitted by /u/IAmNoSherlock
[link] [comments]

:)

 

Clean Install Workaround for Vista

You may remember this news story on techPowerUp! a couple of days ago relating to the lack of clean installs when using the Upgrade Editions of Vista, which required an old OS to be installed. However, Paul Thurrott has managed to find a workaround for this issue, which ironically lets users do a clean install Vista without any previous version of Windows, albeit a little tedious. Here are the steps:

• Boot from the Windows Vista Upgrade DVD as normal
• When prompted for a product code, leave this blank
• Select the version of Vista you have purchased and let Vista install
• When you boot to your desktop for the first time, run the Vista setup from Windows
• This time enter your product key
• When asked whether you want to do an Upgrade of Custom install, select custom and choose a clean install
• Windows will now install for a second time and you should be able to activate it

Remember, these steps are only advised for use in order to achieve a clean install of Vista, it is only legal to use the upgrade editions if you have previously purchased the appropriate version of Windows.

Source: DailyTech

 

OneDrive not running - reset won't work - how to get latest version?

Thanks for the suggestion.
The reason why I wanted to do a reset or re-install is to indeed get OneDrive in that list. Currently it isn't.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".