Windows 10: PC gets blue screen when booting

I tried starting my PC in the Safe Mode and then performed a Clean Boot. I tried a lot of troubleshooting steps without any help.I know that I can reset PC. Please point me in the right direction. Thank you.

:)

 

Startup Blue Screen

Hi Jon,

Startup blue screen error(s) can occur if a problem causes your PC to shut down or restart unexpectedly. It could be due to the following:

• Outdated device software drivers
• Corrupted Windows update system files
• Software/Security conflicts

We would like to know some information:

• Did you get any blue screen stop error codes?
• Have you tried booting in Safe mode?

We suggest that you check this
article about troubleshooting blue screen errors and follow the troubleshooting steps provided there.

We will wait for your response

 

blue screen issue


after monthes of running system it was fine then on windows 7 it blue screened after looking it over myself and getting advice from local pc shop they suggest upgrading os will fix the issue so I upgraded to win 8.1 and along followed the blue screens now again upgrading after more advice I'm on win 10 and the bluescreens followed as a bad pool error rebooting I have included the requested report please help as spending the $150 the local pc shop wants is my next step

 

Blue screen and stop code

Hi
Jeferis,

There are a lot of factors for this matter to occur. To isolate the issue, we have some questions for you:

• 
  What activity have you done to
  trigger the NTFS and FAT FILE SYS loop?
  
• 
  were there any error messages?
  
• 
  What troubleshooting steps have you done so far?
  

It is possible that the
Boot
Sequence were corrupted by the previous activity which
triggered the Blue Screen Error and the loop. We recommend that you perform these
suggested troubleshooting
and see if there are any changes:

Startup Repair.


To access the
Startup Repair Screen, turn off the
PC 3-4 times(force shutdown),
while on the Blue screen Error. This will route you to the
Startup repair screen:

Advanced Boot Options > click Troubleshoot > Advanced options > Command Prompt

and run the following command:

Run SFC Scan:  

SFC
will
scan
and
run
an
automatic repair
to any
corrupted system files
that it will detect. We suggest that you perform it twice. To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Boot Record:

This will fix the corruptions on
boot records or boot
sequence. To run this command, follow these steps:

• 
  Run
  Command Prompt as Administrator.
  
• 
  Type the following command:  
  
  • 
    Bootrec /fixMBR  
    
  • 
    Bootrec /fixBoot
    
  • 
    Bootrec /rebuildBCD
    

Update us on how it goes.

Regards.