Windows 10: Surface go cannot factory reset

I hahe a surface go and its been being alot slowing and has alot less space, so i decided to factory reset it since 90% of the thinfs on there are junk; i go to do that but when resetting it said it ran into a problem and undid all the changes. I also tried repairing but it said the same thing. Any help would be apperciated

:)

 

SURFACE PRO 3 RESET TO FACTORY DEFAULTS PROBLEM

The camera caused a system freeze every time it was activated so I thought why not restore.

• I attempted to reset my Surface Pro 3 to Factory defaults.
• The Surface Pro made it to 1% then crashed.
• Now it is in a reboot loop.

I have tried several times and now it gives an "Unable to reset your PC. A required drive partition is missing" error.

Do you have any suggestions on how to make it work again?

 

SURFACE PRO 3 RESET TO FACTORY DEFAULTS PROBLEM

Hi,

Thank you for posting to Microsoft Community.

The error “A required drive partition is missing” usually occurs when you attempt a system reset or refresh in Windows and the MBR or BCD record is corrupted.

I would suggest you to create a recovery drive. You may go through this article on ‘Creating
and using a USB recovery drive’ to get you through this. Please follow the steps on ‘How to reset your Surface to factory conditions using a downloaded recovery image’ in the same article to get you through the factory reset.

Disclaimer: A reset returns your Surface to its factory settings. It deletes all of your personal files, resets your settings, and removes all apps that you installed.

Hope it helps.

Aaron Summith

Microsoft Community - Moderator

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".