Windows 10: Windows changing diagnostics setting on boot

So I wanted to join the windows insider dev channel. When I went to windows insider program in settings it said to change diagnostics settings to full. I did that then when I went back to the windows insider settings I registered myself as a insider in the dev channel. Then it told me restart the computer which I did. Then when I go back to windows insider it tells me to change the diagnostics setting to full which I had done before the reboot. When I check the settings it was back to the default setting. It seems that windows had changed the setting at boot. Can anybody please help me to solve this problem.

Please note that I have disabled windows fast boot and secure boot since I am dual booting windows and linux. There is no change in boot order windows boot manager boots first and I never boot windows from grub and the boot partition of linux is on another disk and the windows partition were shrunk by the windows partition manger. During linux installation they were just formatted.

:)

 

Sync settings does nothing on new Windows 10 machine

We suggest that you change the Feedback and Diagnostics settings on both devices. Kindly follow the steps below:

• Open Settings.
• Go to Privacy, Feedback & diagnostics.
• Your Diagnostics and usage data settings are probably set to Basic. Just change it to Enhanced or higher.

Once you change Feedback and Diagnostics settings, you should be able to sync your settings normally again.

Let us know how it goes.

 

Instructions to change board?

Boot off of the windows CD, repair your XP partition (hopefully you won't have to reinstall windows), install drivers, and you're good to go. You'll see dual channel mode in the BIOS splash screen results from POST. It'll be pretty obvious *Stick Out Tongue . Here's a list of general tweaks for the 939Dual-SATA2.
Step one- Set time, date
Step two- In CPU settings, disable cool n quiet, set memory clock to DDR400, play with memory timings (CAS-TRAS-TRP-TRCD), which are listed in the bios in the order CAS, TRCD, TRAS, and TRP. EDIT- new BIOS's mess around with this order, can't be too sure on it, but yeah at least you know what the RAM timings stand for *Big Grin .
Leave MA timing at 2T unless you think your system can handle 1T
Step three- in Chipset settings, enable onboard LAN, disable onboard Audio, disable AGP fast write, set primary graphics adapter, and set CPU-NB and NB-SB link speed to 1000mhz.
Step four- in IDE, disable controllers you aren't using. On all drives detected, enable SMART if you can and set PIO/DMA as high as they will go.
Step five- Enable legacy USB support
Step six- Set password if you're worried about anyone screwing around with your BIOS settings
Step seven- Configure your boot sequence. I reccomend hard drive first, optical drive second, and floppy drive third.
Step eight- Save changes, boot into XP, and enjoy your computer.

 

Change Setting for Imprting Pictures in Windows 10

Hi,

Thank you for posting your query in Microsoft Community.

Sorry to inform you that the features you are looking for is not available in windows 10 and it is by default.

There is no such option to get
Import photos and videos to appear in the list like Windows7.

Also I suggest that you provide your suggestions and feedbacks in the dedicated Feedback App. Follow these steps to provide suggestions in Windows Feedback App.

At any time, select Start, and then type
Windows Feedback to send us your opinions and suggestions.
Windows Feedback is only available if you have
Diagnostic and usage data set to
Full (Full is the recommended setting).

To change the Diagnostic and usage data setting, go to
Start , then select Settings > Privacy > Feedback & diagnostics, and then, under
Diagnostic and usage data, select an option.

Please let us know if you have any other queries related to windows 10 we would be happy to help
you.