Windows 10: Couldn't complete the update loop

So there were two updates that I have received that I have tried to install on my laptop. It was KB4569751 and KB4565351. These are the lines in the log: https://pastebin.pl/view/9bc8c60a

Edit: I tried everything I can find but luckily it boots back up again. Now I'm afraid to shutdown my laptop or restart it .

submitted by /u/Zatania
[link] [comments]

:)

 

Windows Updated(16299.309).KB4088776 Restart is required to complete.

Hi dalchina. Good news, I followed your suggestion and reinstalled the update and now it appears as "installed correctly" *Biggrin Maybe it was not necessary to run the Windows Update Troubleshooter or maybe if necessary. But using it I do not think it could have worsened something. The installation was very fast, unlike the first time it showed step 1 and step 2 completed.

Thanks for the suggestions and for the time to respond Best regards.


And thanks for the tip of that program, I'll have it on my list.

 

Lumia 650, we couldn´t connect to the update service

Hi,

Have a lumia 650 with Version 1511, OS build 10.0.10586.494 is this the latest version?

When i check for updates i get this: we couldn´t connect to the update service, we`ll try again later..

I have internet connection via WiFi and a microsoft account set up.

 

"We couldn`t create a new partition or locate an existing one."

Try this:

Before you get to that message, press SHIFT + F10 to open a command prompt.

Run diskpart.
At the diskpart prompt, run these commands:

list disk

At this point you should see the SSD as disk 0. If it has another disk number, use that number rather than "0" in the next command.

select disk 0
clean
exit (to exit from diskpart)
exit (to exit from the command prompt)





That should clear the contents of the disk. The entire disk space should then show up in Windows setup as "Unallocated Space" as in the screenshot below.