Windows 10: Unable to clean disk using diskpart

Hi there! when trying to install windows 10 after it corrupting itself, ive been faced with the issue of not being able to delete the partition of my drive with the system files on it it gave an error code that was something along the lines of 0x80700001, i tried to clean the drive using diskpart however, i ran into the issue where it wouldnt clean the drive as it had system files still on it pagefiles, boot, etc. Any help with this issue would be appreciated.

:)

 

diskpart doesn't show disk

Hey,

I am trying to install Win10 on a mac book air.

However the diskpart does not list the disk even after reformatting the partition as NTFS per suggestion.

read through this solution but cannot move to step 1 listed in the solution by Ivan as that disk doesn't see that partition it was just able to reformat.

Regards

 

DISKPART CLEAN

Hello

I'm Peter F independent Advisor

You will get this error when you are using diskpart clean command on system disk. The system disk contains the Windows operating system files and other critical files, if you are allowed to clean the system disk, all the data and partitions will be gone. That
will result in a lot of errors and chaos. Meanwhile, the delete volume is greyed out in Disk Management. In this case, the new SSD drive may be regarded as the system disk due to the system files, etc.

Using Windows installation disc to clean

If you have the Windows installation disc, you can follow these steps to solve clean is not allowed issue in Windows 7/8/10:

1. Insert the Windows installation disc, then boot from it.

2. Click Repair your computer> Troubleshoot > Advanced Options > Command Prompt.

3. Then input the diskpart commands to clean hard disk:

diskpart

list disk

select disk [disknumber]

clean

Diskpart Clean

Then you could create a new partition on the drive to solve this problem.

Reference

https://www.disk-partition.com/articles/virtual...

This is a non-Microsoft website. The page appears to be providing accurate, safe information. Watch out for ads on the site that may advertise products frequently classified as a PUP (Potentially Unwanted Products). Thoroughly research any product advertised
on the site before you decide to download and install it.

I hope it helps

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!