Windows 10: PC turns on but no power to keyboard, mouse or monitor

I built my PC around 3 months ago and I have had no problems up until now.

When I turn my PC on, all the fans spin on the case and on my CPU cooler and GPU. There is an orange LED that turns on on my motherboard in the bottom left. However, the lights on my keyboard and mouse do not turn on and no signal goes to my monitors.

:)

 

Is it possible to use keyboard/mouse to turn pc on ?

"If" you can get into the PC's BIOS and "if" your BIOS supports it, there's an option to power the PC on by mouse or keyboard...




However, I'm unable to verify if a wireless mouse or keyboard would work because it seems this option is no longer listed in my recent BIOS update so I can't test it. FYI, the image above is from different BIOS posted online.

 

Pc starting but no power/signal to keyboard, mouse or monitor

Hi,

So I've had my gaming pc for a while now.

It runs fine but recently did a factory reset and followed this guide afterwards;ttps://www.youtube.com/watch?v=pJTCwSX9Ym8&list=WL&index=5&t=0s it was fine and so I left it on just downloading a game a few days later, nothing unusual. I came back to it
on but no signal on monitor and no power to keyboard and mouse. I've tried going back to a restore point before following the youtube video and still not working so I don't think that's the problem.

Operating System - Windows 10

Device - Zoostorm Computer

Specs -

ProcessorIntel(R) Core(TM) i7-4790 CPU @ 3.60GHz

Video CardNVIDIA GeForce GTX 750 Ti

Video Card #2NVIDIA GeForce GTX 970

RAM16 GB

Operating SystemWindows 10

But it had been working fine, the only thing I could think of is if I had a pre-existing virus or something that was causing this but surely that would've done this sooner. Anyway, right now when I turn my pc off it does the above again, power to the pc
but no keyboard or mouse power and no signal to keyboard. I have figured out that if I take one stick of RAM out (I have two 8gb RAM) and start it up on just one it all boots up and powers everything fine. I then it off, insert the other stick of RAM and start
it up again and it works. But then I power it off at the end of the day and have to repeat those steps again the next morning. This has been happening for a week-ish now and it's just getting time consuming and annoying to do everyday.

Any help or advice would be appreciated.

Thanks, Lewis.

 

PC turns on, No signal, keyboard/mouse.


Do you own or can you borrow/get hold of a multimeter?

What is your beep code? These are the codes listed by Asus for your board.