Windows 10: Can we reset the settings from Windows ?

So here's my question : can we reset the settings in the Windows setting application ? I would like to put my mouse settings back as they were, but I can't find where I is the option to restart these settings. I wish someone would know...

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

How to reset whole netsh? (Windows 7)

Was wondering has the commands changed somehow since on Windows XP and on Windows Vista 'NETSH INT RESET ALL' cleaned entire netsh up from top to bottom.

Now on Windows 7 this same command says no go and only way I can see it is by building .cmd/.bat which does something like:

Code: netsh winsock reset all netsh int 6to4 reset all netsh int ipv4 reset all netsh int ipv6 reset all netsh int httpstunnel reset all netsh int isatap reset all netsh int portproxy reset all netsh int tcp reset all netsh int teredo reset all[/quote] now the king of the hill of bugs is this doesn't actually do even it's job even after reboot. values setup to are not reset to defaults. (I know I could add more entire list of entries there is, but looking for clean delete/wipe settings & default everything not to dump entire list of resets.)

So, anyone got a plan B?