Windows 10: Driver Verifier with full settings prevent Windows 10 startup

I want to thoroughly check the drivers on my PC with the Driver Verifier Manager application, so i chose "Create custom settings for code developers", enabled everything in the list, and then select all drivers on the computer.After i restart the PC, Windows tries to boot up for about half an hour, after which it gives up and the startup repair screen shows up, where i choose to start in Safe Mode and delete the settings. I was expecting to get a BSOD and a memory dump, but nothing of this sort happens, it seems that the driver tests take too long and Windows decides to give up.Is there a wa

:)

 

Unlocked Realtek HD Audio Drivers Windows 7 & 8 (With Dolby Digital Live and DTS Interactive)

DTS supported natively by Windows 8/8.1 and it should work on windows 10 too just DDL require to unlock your driver .

 

Can't get GPU-Z to start with Windows 8.1 startup

I'm not sure how to do that. Could you list the steps for a noob?

 

windows 10 no advanced-startup-options, so no startup settings

when i did 1. 2. 3. steps i checked and problem was SOLVED
but after 4. 5. 6. 7. steps i checked and no advanced startup options again

1. Make a complete backup image of your current HD including all partitions to an external HD using macrium reflect . Once done, disconnect all USB devices from the PC. Assuming now you only have one HD connected to the PC which you will be installing Windows.
   IMPORTANT: Also create a Macrium Rescue disk to boot from later on.
2. Boot up your Windows installation USB/DVD. On the first screen, Hold SHIFT + F10 to open Command Windows then type:
   Diskpart
   select disk 0
   clean
   exit
3. Click Next, Choose Custom, select the unallocated partition then click Next (Do not format), when asked for Product ID key, click on "Skip this step"/"Do it later". Continue the Installation.
4. Once done. With the external HD connected, Reboot your PC with the Macrium Rescue disk, select the image that you created in step 1 as the Source.
5. Select your current HD/SSD as Destination disk
6. Restore only C: Drive to it. ie. overwrite the new C: Drive with your backup C: Drive.
   NOTE: See screen shot on how to perform this step
7. Disconnect all the external devices. Reboot. Windows should perform a startup repair.

till 4. step there was no windows 10 key activeted and problem vas solved
but after step 7 i checked key and it was not the same which i purchased, why did that change? i activated purchased key again.
so is the problem to be a windows 10 key on my pc?
or do some drivers prevent advancedstartup options?