Windows 10: multiple BSOD's after startup

To start off, my specs:
Win10 64-bit
AMD Ryzen 5 3600
Asrock B450 PRO4
2x Corsair 16 GB DDR4-3200
970 EVO PLUS SSD
be quiet! Pure Power 11 600W CM

BSOD's usually happen in the morning 1-2 times, or when I run games/programs that heavily use the GPU. I also noticed that they appear slightly less when I have less USB devices attached. Overall they vary from DPC_Watchdog_Violation to DRIVER OVERRAN STACK BUFFER, but I dont have the knowledge to see a red thread between the messages. The GPU...

Read more

 

Can't get GPU-Z to start with Windows 8.1 startup

I'm not sure how to do that. Could you list the steps for a noob?

 

HP laptop - multiple BSODs

I have an HP Pavilion 15-cs0021na, (Intel i3, 8GB, 128GB SSD) running Windows 10 Home, which exhibits the following characteristics:

• On startup, occasionally completes boot, but within 5 minutes, BSODs. with a random error, e.g. Page Fault, IRQL not equal, Memory Management and so on.
• Repeated attempts to reboot then fail with more random BSODs
• Rarely, it will attempt a Startup Repair – which will invariably fail with another BSOD.
• Wiping the hard disk and attempting to install a clean version of the OS (downloaded from Microsoft using Media Creation Tool to USB stick) will get a little way into the process, then fail with BSOD as above.

What I’ve done:

• Attempted clean install as above.
• Run multiple hardware tests on Memory and SSD - HP’s built-in tests, Memtest86, Seagate disk tools. All tests pass with no errors.
• Updated BIOS from Insyde F.04 to F.22 (HP supplied).
• Repeated clean install, same result.

I have now run out of ideas, and am at a loss to understand what is causing these errors. How are BSODs generated if no Windows installation is present? Is it likely that a hardware component other than RAM or the SSD is causing these?

Any and all suggestions will be much appreciated.

 

BSOD when coming out of sleep, multiple error codes

Thanks for the assistance, I've run all the necessary steps. It looks like there might be an issue found when running that first command. I have also installed all the driver updates recommended by the dell support check.

You can find the logs of the command prompt window in the cmd.log file

cmd logs.txt