Windows 10: How to configure wifi for hotspot and connect to local wifi AP two wifi devices?

I have two wifi devices internal and extarnal via usb, I want to use one for hotspot, the other to connect to local wifi access point. How can I set this confiiguration?Thanks

:)

 

Configure AP Mode with Same SSID to extend WiFi signal

When I reset the wifi on my cellphone it will connect fine to the AP wifi, same happened with my laptop, but the other devices no luck, my tablet is trying to con constantly and my other laptop says no internet secured.

 

Configure AP Mode with Same SSID to extend WiFi signal

Sounds like the AP is not passing traffic or has a delay. If you leave the router WiFi off, disable WiFi on a phone, reenable wifi on phone and reconnect to WiFi (being broadcast by AP) does it connect? If not, double check that you set the APs Gateway properly and that means it should be your router...that's something your screenshots did not show.

 

Wifi turns off automatically when a device is connected to my hotspot


Whenever a device is connected to my hotspot the wifi is turning off automatically thereby stopping the hotspot.

To turn the Windows 10 hotspot on, in first step I have turned on the Wireless Network Connection as shown in the below image.





After that I did following steps in Command Prompt(Admin) for hotspot
1. netsh wlan set hostednetwork mode=allow ssid=MyWiFi key=mypassword
2. netsh wlan start hostednetwork

In netsh wlan show hostednetwork command, it shows the hotspot had started successfully as shown in the below image.





But whenever a device is connected to this hotspot the wifi is turning off automatically thereby stopping the hotspot.





I have unchecked the Power management option i.e, Allow the computer to turn off this device to save power.
All driver are updated to the latest versions.

Please help