Windows 10: Recently factory reset my computer and now this is all thats showing up. Whats happening...

It wont let me.upload the image so here's a link for it. I just need to know whats actually going on.https://ibb.co/XrGbp074

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Recently Reset Computer

Hi,

Black screen issues may happen due to several reasons. One of these is due to outdated or incompatible display drivers. For us to properly assist you in rectifying the black screen concern, supply more information by answering these questions:

• What is the make and model of your computer?
• May we know what prompted you to reset the device?
• Have you recently installed any updates?
• Are there any third party applications or software installed on your PC?
• What steps have you taken so far to resolve the issue?

Your response is greatly appreciated.

 

Diskpart : there are no fixed disks to show.. Factory reset gone awful

Hi everyone, I was asked to factory reset an Asus laptop and install a win 7 on it, while starting to install the win 7 I got stuck with the "no device drivers were found", searched for some tutorial on YouTube, found this vid: , followed the command codes step by step on MS-DOS : ( Diskpart >>> list disk >>> select disk 0 >>>> Clean >>>> create partition primary >>>> format fs=ntfs quick) and now I completely lost the disk 0 with all system files, no hard drive showing as a boot option in the BIOS. Am I screwed ? Is there a way to create or reactivate the internal HDD ?? Thank you in advance for your help