Windows 10: No Signal After Display Sleep

I use an OLED monitor, so I have a pretty aggressive display sleep setting of 2 minutes. Shortly after the display enters its standby state, I hear the device disconnect sound from Windows. When I then go to wake the system which is not in a sleep state, just the display, the monitor does not react, but remains in standby. If I manually wake the display via its buttons, I get a no signal message. I can still log back in and interact with the PC, albeit completely blind, but the display will not get a signal until I restart the graphics driver via the Windows + Ctrl + Shift + B keyboard short

:)

 

Display and sleep settings

Hi,

In order to help you with the issue about the display and sleep settings, kindly answer the following questions:

• Have you tried the troubleshooting steps suggested by MVP Andre Da Costa? If you did, what were the results?
  
• For us to avoid redundancy of the troubleshooting process, what were the other steps you have done to resolve the issue?
  

We look forward to your next post.

Regards.

 

Display will not sleep.

Hi,

Thank you for posting your query in Microsoft Community. I understand the inconvenience caused to you and will help you solve the issue.

I suggest you to follow the steps provided below and check if it helps.

• Click on Start>Settings>System.
• In the left navigation pane, click on Power & sleep.
• In the right pane, select the time limit for the system to go to sleep from the drop down list.

Hope the information is helpful. Keep us posted on the status for further assistance.

 

INPUT SIGNAL OUT OF RANGE while playing Wizard 101

Hi,

Thank you for writing to Microsoft Community forum.

• Since when are you facing this issue?
  

This happens if the signal from the video adapter exceeds the scan range of the monitor. The video card is feeding the monitor a signal stream in excess of what the monitor can accommodate. The two main causes for this are that either the resolution
or the vertical frequency is set high.

You may try the troubleshooting steps listed in HP and Compaq Flat Panel Monitors - Flat Panel Monitor Displays Message about
No Signal, Signal out of Range, Sleep, or Power Save and check if it helps.

Regards,