Windows 10: Can a install a windows 7 drive into a dell tower to replace a drive running vista

Can I install a windows 7 drive into a different pic which was running vista

:)

 

Vista/Windows 7 on same drive?

Lol it's not exactly like that. I'm lolling because it really is funny and weird on the computer but you can access any OS any time.

So I made a partition on my C: drive using Vista disk management, and named the partition G:
Installed 7, and it works fine.....

When I'm in Vista, it's normal ie my Vista drive is drive C and my 7 partition is drive G.

When I'm booting using Windows 7, my G drive (the one with 7) appears as drive C.... and my Vista drive which is usually C appears as drive B. *Laugh :laugh:

Other than this letter confusion, everything works fine. *Toast :toast:

Here is VISTA:




And here is WINDOWS 7:

 

Installing windows off of a USB stick

Step By Step from vista:
From admin cmd prompt

1. diskpart
1a. list disk
2. select disk 1 (replace 1 with your usb drive)
3. clean
4. create partition primary
5. select partition 1 (replace 1 with your usb drive)
6. active
7. format fs=fat32
8. assign
9. exit

Copy Windows Vista's DVD ROM content to the Flash Drive

xcopy d:\*.* /s/e/f e:\ (d being your vista cd and e being your usb stick)

And that's it, boot off your usb disk

 

How to Partiton a Hard Drive in Vista

This is a way to get Vista to see another hard drive that is not associated with the OS. There is some times when your new hdd doesn't seem to want to work well with Vista. But, there is a solution in it.

Open the Computer Management By doing these steps.

• Click on the Start Button
• Click on Control Panel
• Click Administrative Tools
• Double click on Computer Management

You are now in the Navigation panel of the Computer Management.
When in Computer Management, you then have to allow the new drive to be recognized.

• Double click on Storage
• Double click on Disk Management

Now in the middle of your screen there is the layout of the Disk Drives that you have. The drives that are partitioned will show by the drive lettering. The others will just show up as having nothing at all in them. Below that there will be the Disk drives that are installed into the computer. You'll see that the primary one will all ways read as "Disk 0". Then you will have Disk 1 and so on. Under the Disks there will also see your CD-Rom drives.. If there is more then one, it will be labeled the same as Disk drives..

On to the Partitioning of the drive in question.

• Right Click on the drive
• Click to format the drive or Enable Volume. There will be a series of windows that open up. This is Vista's formatting. Just go threw the windows, and make sure everything is the way you want it to happen.
• Once the formatting is done, will take some time depending on the drive size.
• Right click on the drive
• Click on Mark the Partition as Active

After you have done those steps, The drive will be up and running threw Vista.



:Side Notes:
If you are not the Administer to the Os, then you will have to enable it..
You may also want to redo the drive lettering of it all. But, I really don't see a reason to do so. If you do, you have to redo drive paths and so forth.. A lot of work on something so small...