Windows 10: Lenovo Mix 2 with windows 10

I updated my Lenovo Mix 2 tablet to Windows 10 and now tablet mode stopped working. Any workaround?

:)

 

lenovo Mixed reality controllers

Hello Bill,

To better assist you with your concern, I'd like to know the following:

• Confirm which build is currently installed on your device. To check, follow the steps below:

1. Press Windows key + R, then type in winver.
2. Click OK.
3. Were there any recent changes made prior to this issue?
4. Are you getting any specific error messages when setting up the Mixed Reality Controllers?
5. What is the make and model of your computer?

Upon researching, it was stated in this article that KB4284848 "Addresses a performance issue with Windows Mixed Reality on some laptops with hybrid graphics adapters, such as Surface Book 2".
If you're using a laptop that supports hybrid graphics adapters, then its advisable to install the said KB update.

In addition, here are some articles that may help you troubleshoot your Mixed Reality Controllers:

• Troubleshooting Windows Mixed Reality
• Using Windows Mixed Reality FAQ

Looking forward to your response.

Regards.

 

Lenovo Explorer Windows Mixed Reality not working on my laptop

Hi,

Thank you for writing to Microsoft Community Forums.

To have better clarity on the issue, answer the below listed questions and get back to us.

1) Has the Mixed Reality Headphone ever worked on your Lenovo Y700?

2) What is the error message you get when you connect your headset to Lenovo Y700?

You can check if your Lenovo Y700 is compatible with Mixed Reality by installing
Windows Mixed Reality PC Check
application.

If your Lenovo Y700 meets the hardware requirements, then you can try and
Set up Windows Mixed Reality.

You can also refer Get
help with PC compatibility in Windows Mixed Reality and see if this helps.

If you are still facing issues with your Mixed Reality, then you can follow
Troubleshooting Windows Mixed
Reality.

Hope it helps.

 

Windows 10 1709 System Restore problems...


That seems to be an attempt at Option 2 in the tutorial, which requires you to
a. Boot to a command prompt (Did you?)
b. You then seem to be mixing steps 3,4 and 5, thus your command is incorrect.

I suggest Option 1 is easier.

If you still have problems, please repost listing each specific step and saying which option from the tutorial you are using. Thanks.