Windows 10: 2 PC's connected to one router 1 isn't working

Hi so i have a friend in which he is having some issues with one of his pcs connecting to wifi.


I first asked him if the computer that isnt working, was saying connected to the wifi but no internet access.

He then replied with this:

"its connecting fine then disconnects or goes slow and says something about the gateway and fixes it when running diagnostics then does it again constantly"


I have suggested thag the 2 pcs may have the same ip adress which is causing them to conflict in which case im not sure how to fix if thats the case


If there are any other reasons or a way to fix the issue suggest above i would be very happy to hear solutions


Thanks in advance

:)

 

Printer isn´t working after latest update.

After the latest update from Windows, my Canon Pixma ip6600 printer isnt working. In Device Manager it shows up as working properly but when I go to print it isn´t listed as an option in any programs. Troubleshoot suggests it´s a USB 2 printer on a USB
3 port and that that´s the problem but that cant be since it worked fine before the update. I´ve tried to uninstall and plug it back in but that doesn´t work either.

 

Cortana isn´t working

When I hit enter, it did something, but there´s still no Cortana, even after restart. So I tried it again, but now it says that it failed, because it´s already installed and it´s working in PC. So it should work, but Cortana still isn´t here.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".