Windows 10: 5 years after, the same issue with DisplayPort is there

I was reading this topic:

https://answers.microsoft.com/en-us/windows/forum/windows_10-hardware-winpc/windows-monitor-auto-detection-issue-again/bf07ddd9-aa81-4b70-99f2-924b399cfc74?auth=1

To my surprise, that almost 5 years after the same issue it's there. The solutions given are extremely weird: using a little software that monitors the information in the screen, or plugging in a DVI to the secondary screen to maintain the hot plug...


Drivers have not improved either, my latest Radeon drive still has this problem even with a different graphic card 6 years later


I'm just writing this because maybe has found a more elegant solution to this problem

:)

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

DisplayPort audio issue with Windows 10


I'm using a Surface Pro 2. After my upgrade from Windows 8.1 to Windows 10, I'm not getting any audio out from the DisplayPort.

I use DisplayPort to HDMI to a receiver. I've upgraded to the latest RealTek audio drivers, but it's not helping. Could there be a different driver issue at play?

Any suggestions appreciated.

 

Windows 10 unstable in dual screen setup displayport + hdmi

I just changed my system from an intel i5 2500k to an amd r5 1600 and with almost the same hardware (only changed cpu, motherboard, ram and switched to a m2 ssd as windows drive) and windows version (freshly
resinstalled) windows crashes when I turn my displayport screen on again in dual screen setup with an hdmi screen.

System Configuration:

Motherboard: MSI X370 gaming pro carbon

BIOS: 7A32v17 (AGESA 1.0.0.6)

CPU: AMD Ryzen 5 1600

Memory: 16GB DDR4 3200 (G-Skill F4-3200C16D-16GVKB)

GPU: MSI RX 480 gaming x 8GB

VBIOS: 015.050.000.000

GPU Driver: 17.7.1

OS: Windows 10 Pro N x64 (15063.483)

Steps to Reproduce:

• 
  Plug into gpu ports: BenQ XL2730Z @ displayport, Philips 273P3LPHES @ hdmi
  
• 
  turn on pc and displays, wait for windows login
  
• 
  turn off displayport display
  
• 
  turn on displayport display
  
• 
  what now happens: displayport display stays black (no signal), hdmi display turns black (no signal), pc unresponsive
  
• 
  after 10 - 20 seconds pc reboots automatically
  

Expected Behavior:

displayport display should turn on normally without crashing the pc in dual screen setup

Actual Behavior:

displayport display causes crash when turned on again

Additional Observations:

Turning the hdmi monitor off and on does not crash windows even if displayport display is plugged in.

Unplugging the hdmi monitor and turning the displayport monitor off and on does not crash windows.

I used the exact same hardware and drivers before with an Intel i5-2500k and an Asrock Extreme 3 gen 3 without these issues. Windows and drivers were completely reinstalled though after switching to Ryzen.

***Post moved by the moderator to the appropriate forum category.***