Windows 10: 802.1x authentication

We have set 802.1x authentication enabled in Windows 10 with authentication mode set to user authentication. We want to provide these credentialsusername and password from our own UI. Is there any way we can set these credentials from command prompt or cli? We don’t want user to go to the network adapter properties and set it from there.

:)

 

802.1X environment problems with authentication after 1903 update

Since the 1903 update i have been experiencing authentication problems with some windows 10 machines in our network. Are there any more information about this issue than what was suggested

here?

 

Windows 10: Microsoft Protected EAP (PEAP) - 802.1x Authentication Credentials (User Authentication) are lost after updates every time

Hi Sanjailal,



Thank you for writing to Microsoft Community Forums.



I understand that your query regarding 802.1x Authentication Credentials. Let me point you in the right direction, I would suggest you to post your query in
TechNet forums, where we have support
professionals to address your query.



Here are few articles for reference:

• Configure 802.1x Authentication with PEAP, ISE
  2.1 and WLC 8.3
  
• Advanced troubleshooting 802.1X authentication
  
• [MS-PEAP]: Protected Extensible Authentication Protocol (PEAP)
  

Regards,

Nikhar Khare

Microsoft Community - Moderator

 

802.1X authentication fails after connecting to a network in Windows 10

I am encountering a problem with Windows 10 1607 LTSC version andI found a similar case as reference in the following link:

https://support.microsoft.com/en-us...ils-after-you-connect-a-computer-to-a-network

I am able to reconnect to the network by restarting the Wired AutoConfig service.

Is there any solution for this situation in Windows 10?

Thank you so much.