Windows 10: a friend put in an ssd with no sata and now pc turns on but no display or bios

things tried reseating gpu, removing cmos, unplugging displays, removing 2 ram sticks, removing the drive without a sata, plugging in drive with a satahe plans on trying to use a flash drive with windows on it although i dont think it'll fix the issue

:)

 

No SATA settings in Bios

I installed a SSD in my dell computer and I want to change the SATA settings to AHCI - problem is I am unable to find where to change that setting in the BIOS. In fact, no where does it even mention SATA. I've tried all the suggestions of going to the
registry and changing the values - but again there is no where in the BIOS that I can find to change the SATA.

Any help would be appreciated.

 

My pc will only turn onto the bios settings

If your PC is only turning on to the BIOS settings and you are unable to boot into Windows, it may be due to a hardware issue or a problem with the operating system. Here are some steps you can take to try and fix the issue:

1. Check the boot order in BIOS:
   

• Enter the BIOS settings by pressing the appropriate key (usually F2 or Del) during startup.
  
• Look for the "Boot" or "Boot Order" section and ensure that the hard drive or SSD that contains the operating system is set as the first boot device.
  
• Save any changes and exit the BIOS.
  

1. Check for loose connections:
   

• Turn off your PC and unplug it from the power source.
  
• Open up the PC case and check all connections between components (such as the hard drive or SSD and the motherboard) to ensure they are properly seated.
  
• Close the PC case, plug it back in, and turn it on to see if the issue is resolved.
  

1. Perform a startup repair:
   

• Use the Windows installation media (such as a USB drive or DVD) to boot into the advanced options screen.
  
• Select "Startup Repair" and follow the prompts to attempt to repair any issues with the Windows operating system.
  

1. Reinstall Windows:
   

• Use the Windows installation media to perform a fresh install of the operating system.
  
• Note that this will erase all data on the hard drive or SSD, so make sure to backup any important files beforehand.
  

If none of these steps solve the issue and you continue to see the "no bootable device detected" message, it may be due to a hardware failure such as a faulty hard drive or SSD. In that case, you may need to replace the failing component or seek professional assistance.

 

PC Build Steps

Ok just because I like steps i am going to create some steps. Please give me the stamp of approval/disapproval

• Install system in case
  • Remember to connect SSD and optical to same SATA ports on motherboard
• Turn on PC
• setup HDD
• run blend test in prime95 for 30-60 min
  • run realtemp at the same time

• While in Prime95 test
  • if CPU goes above 70c in RealTemp, I have a leaky CPU
  • if my system locks up or blue screens, there is an instability in the system somewhere
  • if my system does not lock up or blue screen, my CPU is not damaged and I am in the clear!

What do you guys think??