Windows 10: access files after resetting computer

I had to reset my computer and can't access turbo tax files. how do I do that?

I'm getting "parameters are incorrect" error message.

:)

 

One computer cannot access other network computers.


So I've tried every troubleshooting step I know:

• Double checked that Net Bios was enabled
• Ran a bunch of network commands:
  • flushed DNS
  • registered dns
  • pinged and located the named computers successfully
• Reset my router to factory settings

Nothing works when I try to access via explorer. I'm still baffled by the fact that every other computer can access each other AND access this computer. It's just the outgoing connection from this machine that doesn't work.

Any thoughts?

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

No access to Disk and wont allow me to Reset the Computer.


This is the problem I have: It won't let us access the local disk and says we don't have permission. I am the only user. It won't let us save anything on that disk either. I have gotten all of the documents, videos, and pictures backed up so that's not an issue. We are really just trying to reset the computer with a fresh start but it wont let us.

Okay so this is everything i've tried:

Resetting the computer- This wouldn't let me because it said it had an error. I did this by holding shift while restarting and then troubleshooting from there. I've tried the option of saving files and also whiping the whole computer, both ways won't work.

Booting in safe mode- it works but nothing has come out of doing anything in that mode.

What do I do? I've read multiple forums and nothing they suggest is possible. Suggestions?