Windows 10: Accidentally pressed shut down instead of restart after typing bcdedit /set {current}...

Hi I was trying to figure out how to speed up the write speed of my new ssd and saw that I had to enable AHCI which required me to type in - bcdedit /set {current} safeboot minimal in command prompt. But then instead of restarting, i accidentally clicked shut down and now my monitor won't turn on even when cpu is running. What do i do

:)

 

AHCI vs regular Native IDE


If you want to change IDE to AHCI in windows 10, without a clean install, do the following steps:

• Open Command Prompt (Admin)
• type: bcdedit /set {current} safeboot minimal
• Restart PC and go into you BIOS -> Set IDE to AHCI
• Windows 10 will start if Safe Mode
• Open Command Prompt (Admin)
• type: bcdedit /deletevalue {current} safeboot
• Restart and Windows 10 should load with AHCI enabled now

Until now, I had a 100% succes rate with this, but in the case Windows 10 wouldn't start, go back into your BIOS and set AHCI to IDE.

 

Random shut down and restart??

Computer: Intel (R) Pentium (R) Dual cpu
E220@2.406hz
2.42 GHZ, 2.00 GB of RAM
Windows xp

Ever since I replaced the fan (with heat sink) the computer has randomly shut down and then restarted, at first during streaming, and now, will shut down and restart anytime. I tried to replace the graphics card to no avail. *Confused *Mad

One suggestion was to replace the RAM.

Any suggestions on how to repair my computer?

 

Laptop restarts when i try to shut down

What methods have you used to shut it down? The usual ways are to open Start, click the power icon and then choose Shut Down. Alternatively you can go onto the desktop and press Alt+F4 to open the shut down/restart dialog. Third,
type "shut down" into the Start search and click the "shut down" entry.

Also see
this forum post from 2015. Microsoft staff member answer below copied from linked:

I suggest you to follow the methods below and check if it helps.

Method 1:

Disconnect all the external devices (printers, scanner, USB (universal serial bus) drives, etc...) Except mouse and the keyboard and then try to shut down.

Method 2:

I suggest you to run in-built Power troubleshooter and check. Follow the steps:

• Press Windows Key + X.
• Click on Control Panel.
• Select Troubleshooting on the left pane, click on
  View All.
• Click on Power to run the troubleshooter.

Method 3:

If the above method doesn’t help, I suggest you to reset and restore all of the default Power Plans back to their default settings. Follow the steps:

• Press Windows Key + X.
• Select Command Prompt (Admin).
• At the command prompt, type powercfg -restoredefaultschemes, and then press
  ENTER.
• At the command prompt, type exit to exit the Command Prompt window.
• Restart the computer and check with the issue.

Method 4: Clean boot

Putting your system in Clean Boot state helps in identifying if any third party applications or startup items are

causing the issue. You need to follow the steps from the article mentioned below to perform a Clean Boot:

How to perform a clean boot in Windows - Microsoft Support

Note: After clean boot troubleshooting steps, refer to the section "How to reset the computer to start as usual after troubleshooting with clean boot"
in the provided link to return your computer to Normal startup mode.

Hope this information is helpful. Please do let us know if you need further assistance, we’ll be glad to assist you.

Thank you

Ravindra R Kamath

Microsoft Community