Windows 10: Accidentally shut off my pc during a factory reset and now it’s in a boot loop how can I...

My computer is stuck in a boot loop just in the loading screen and it doesn’t appear like there is a way for it to stop all I see is it starts turning on then the screen goes black then the motherboard flashes red then orange then green then it restarts the boot loop process where it loads then stops loading is there a way to fix this issue this happened as I was factory reseting it and i had to turn it off because there was no progress during the reset

:)

 

Windows 10 Factory Reset Infinite Boot Loop

Hello,

As you are facing issue with Boot loop, I suggest you to perform a Startup Repair by following the steps provided below:

• Go to the Microsoft software download website and create Windows 10
  installation media.
• Insert the installation media you created, and then restart your PC.
• On the Install Windows screen, select Repair your computer.
• On the Choose an option screen, select Troubleshoot>Advanced Options.
• Click on Startup Repair.

After the repair is complete, check for status.

Hope this helps. Keep us posted on the status for further assistance.

Thank you.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Windows 10 Factory Reset Automatic Repair Loop

I recently received a used Dell laptop from a family friend. Typically, I am able to repair and/or reset any laptop that I lay my hands on, but I was not informed that this one ran with Windows 10. As I booted it up, I was immediately thrown into this constant
loop of "Preparing Automatic Repair"....."Diagnosing Your PC"....reboot and Dell screen...."Preparing Automatic Repair"...."Diagnosing Your PC"....and again, the reboot.

I was told that this particular laptop had been performing a factory reset when it was accidentally shut down and restarted.

I am unfamiliar with Win10, so I don't know what to do at this point.

What can I do to repair this laptop and get it functioning properly again?