Windows 10: add device!!

hello again..... ive been trying to add my t580 samsung tablet to my laptop to no avail...ive been sitting here for 3 hours waiting and nothing has happened....help, many thanks charlotte mueller

:)

 

Taskbar bug: switching to another window -will not appear at the front


Follow either of these steps to fix the issue with the Active window hiding behind.

Method 1:
I suggest you to disable window by hovering over it with the mouse and check if it helps. To do so I suggest you to try the below given steps and check if it helps:

1. Press Windows key + X key and click on Control Panel.
2. Select or click Ease of Access.
3. Click or tap onEase of Access Centre.
4. Click on Make the Mouse Easier to Use was uncheck Activate Window by hovering over it with the mouse.
5. Check if issue is resolved.

Method 2:
I would suggest you to completely uninstall the touchpad driver and reinstall it. Kindly follow the below given steps.

1. Press “Windows key + X” and click on “Device Manager”.
2. In the list of devices, you should see the touchpad drivers.
3. Right click on the device and then select "Uninstall".
4. In the uninstall dialog, make sure you select the option to delete the driver package from the system. This causes the driver package installed earlier to be deleted.
5. In the Action menu of Device manager, select “Scan for Hardware changes” option. This will cause the device driver to be reinstalled. Once the driver is installed, close all windows and restart the computer.

 

Taskbar bug: switching to another window -will not appear at the front


I have been trying to fix this for months. Your solution Method 1 seemed to work. THANK YOU!!!!

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".