Windows 10: After doing a complete Reset of the computer why is everything still on my laptop and it...

I would like to know why I did a clean installation of Windows 11 using the Windows Media Creation Tool Nothing changed. everything is still as if I didn't do the complete installation. I have done a normal system reboot and that didn't work I did a complete system diagnosis and says nothing is wrong, yet I can get into my email and some programs that I used to do. This started a few weeks ago, thus me trying to rese to a factory reset. Nothing has worked in any way form or fashion. All thy information and files and programs are still on the computer after it says the install was complete.

:)

 

Windows Updated(16299.309).KB4088776 Restart is required to complete.

Hi dalchina. Good news, I followed your suggestion and reinstalled the update and now it appears as "installed correctly" *Biggrin Maybe it was not necessary to run the Windows Update Troubleshooter or maybe if necessary. But using it I do not think it could have worsened something. The installation was very fast, unlike the first time it showed step 1 and step 2 completed.

Thanks for the suggestions and for the time to respond Best regards.


And thanks for the tip of that program, I'll have it on my list.

 

Bought computer in Germany - how to reset the laptop to be completely

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".