Windows 10: After factory reset PC will not go further than circling dots

I did a factory reset after the reset was finished. The PC will not go any further than the first window of circling dots, then shutting down and starting up again continuously. I attempted to use a flash drive with windows 10 but it would not work, it continued to start and stop with the curling dots. Prior to the reset the PC had been working slow but fine.ACER XC-704g.

:)

 

After factory reset PC will not go further than circling dots

I did a factory reset after the reset was finished. The PC will not go any further than the first window of circling dots, then shutting down and starting up again continuously. I attempted to use a flash drive with windows 10 but it would not work, it continued to start and stop with the curling dots. Prior to the reset the PC had been working slow but fine.

ACER XC-704g.

 

Black Screen with circling Dots

I have been having trouble with windows 10. One of the articles suggested to hold down the start button 3 times and start the PC 3 times. I did and the screen started going through stages of fixing. The Screen went black with the circling dots for the
last 6 hours or so. I pushed the stop button and restarted the PC. Windows logo came up but then went to black screen with the circling dots. Can someone help?

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".