Windows 10: After factory resetting windows the computer won't detect 2 monitors

After i factory resetted my gaming pc windows 1 doesnt know the name of the graphics card anymore and 2 Thinks that there is only one monitor connected even on device manager but shows the same the screen of both monitors

:)

 

Ive factory reset my computer but I can't use the mouse or the keyboard to select laugage

Hi,

A device like your keyboard and mouse is not detected during factory reset.
To help us determine the appropriate troubleshooting steps
that can resolve your concern, we would like to ask the following questions:

• Are you performing a factory reset on a laptop or a desktop?
• Is this the first time you perform a factory reset on your device?
• What troubleshooting steps have you done so far to resolve your concern?

In the meantime, if you're working on a desktop, we suggest that you try to use a PS2 keyboard just to bypass the installation process. Once Windows is up and running, you may now plug your mouse and keyboard to initialize Windows to detect these devices.

We look forward to your response.

 

Need help, Computer no longer detects NVIDIA graphics card

I removed the gpu and rebooted but the monitor still can't detect any signal. I made sure the computer was off and unplugged before clearing the cmos.

I followed these instructions
3 Ways to Reset Your BIOS - wikiHow

When I reached step 10 the monitor didn't find signal from the computer.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".