Windows 10: After failed Microsoft upgrade Ethernet doesn’t have valid IP configuration

Ethernet doesn’t have valid IP configuration. I have network coNnect but no internet. Tried ping, works, tried manual IP and DNS did not work. I also have stopped and restarted all network config, reset the network to factory specs. Downloaded new driver for realtek PCIe fe family controller and used usb to install to ver 10.14.123.2017. Reloaded windows, did a fall back recovery etc In event log device PCI\VEN_10EC&DEV_8136&SUBSYS_FC301179&REV_5. … had a problem startingPrevious warning in log: Device PCI\VEN10EC&DEV_8136&SUBSYS_FC301179&REV_5. … was not migra

:)

 

Ethernet dosen,t have a valid ip configuration

It says the same thing at my end when my Ethernet is working perfectly as shown below:

 

Ethernet dosen,t have a valid ip configuration

Hi My erthernet connection stoped working, and I can't get it going again. It stopped working after I was looking at some network programs on a PE rescue disk, that i had not used before. Whether It was something I done or it just died I don't know.
Windows 10 10.0.18362 and tried 10.0.19035
Cable has light when you plug it in
Network connections says "unidentified network".
Troubleshooter says "Ethernet dosn,t have a valid ip configuration"
Device manager has everything listed as working.
Network connections Status window says IPv4 no network access, IPv6 no network access, speed 100.0 Mbps, Diagnose says, "Ethernet dosn,t have a valid ip configuration"
I uninstalled all network adapters, restarted and reinstalled network adapters.
I reistalled Windows 10, still not working.
Any help would be appreciated, Thanks Shane.

 

ethernet does not have a valid ip configuration

Hi Chrisoffer,

You may try the suggestions posted by Vijay B on December 10, 2013
on a similar issue.

http://answers.microsoft.com/en-us/...guration/87c635f3-34b4-4e9e-8326-7c24750b88bf

(Steps hold good for Windows 10)

Do let us know if you are able to connect to internet through Ethernet. Thank you.