Windows 10: After getting laptop from repair. It has been reset and this is now here. What is it and is...

submitted by /u/texmexguacamole
[link] [comments]

:)

 

Windows 10 Advanced Options Menu to Repair

I would try the following steps in order:

1. Remove the laptop main battery for a few minutes - may reset something
2. Load BIOS defaults
3. Install Macrium Reflect Free on another PC, create a Reflect USB repair disk then use that disk to repair your laptop
4. Recover from backup if you have one
5. Perform a Windows 10 repair install - see instructions on this forum

 

Laptop Reset Loop

Hi Vince,

Let us resolve your concern regarding frequent reboot. We suggest that you follow the Startup Repair steps below:

• Turn off your laptop.
• Turn on your laptop. As soon as you see the Windows logo with the spinning dots, press and hold down the power button until your laptop turns off. Do this process
  twice.
• Turn on your laptop for the third time, and let it load.
• It should give you the message: Preparing Automatic Repair.
• On the next screen that would appear, click on Advanced Options.
• Select Troubleshoot.
• Go to Advanced Options.
• Click on Startup Repair.
• Wait for the repair to finish.

We would appreciate it if you could get back to us and provide us your feedback.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".