Windows 10: After replacing the thermal paste on a laptop, I periodically get a fatal error video...

What I have tried to fix the error:- reinstalling drivers- clean reinstallation of drivers using the DDU utility- bios rollbackI also want to note that after assembly, all the wires were checked inside the laptop were checked.Diagnostics power-batteries \ video cards \ chipset did not reveal any errors.Сonsole commands sfc /scannow and dism /online /cleanup-image /restorehealth did not bring any results.All latest updates installed.All solutions above save from the error for a while, after a few hours / days the error is reproduced again.Help me please :

:)

 

Replace thermal paste regularly

Well i replace my thermal paste every 9 months(Well you can call me a thermal paste specialist*Cool )

When the thermal paste gets dry or evaporated then you CPU reaches high temps!
I will suggest to check(and replace it if it is dry or evaporated) every 10-12 month but if you live in hot places like India i will suggest to do it every 9 months*Toast :toast:
Well your GPU also needs thermal paste to cool up!*Cool

Well i could made my video for How to remove old thermal paste and install a new coat but i don't have a tripod and no one to hold the camera for me but anyway i searched on youtube and i found this video is the best(The video is at the end of the post) and i will say you must not use normal tissue paper! and the video is demonstrated on a i7 2600K however you can use a different company for the thermal paste but i will recommend to use Artic Silver 5 and for the cleaning solution you can use any cleaning solution !*Big Grin

Do you think this is a small and tiny tutorial?*Roll Eyes
*Rockout :rockout:

The youtube video below

 

Best thermal paste

Most decent thermal paste is about all the same (1-2 degree difference). Without knowing the two listed, (I use MX-2), I would suggest going with the one that is non-conductive.

 

Fatal Error

I've been trying to format my system but right after it finishes formatting I get a Fatal Error during the Windows installation process. That Fatal Error is a Data Error (cyclic redundancy check). I know that it's because of my hard drives, but how do I fix this issue? I have 2 Seagate Barracuda 7200.10 250GB SATA II Hard Drives in RAID 0. Any help and suggestions would be greatly appreciated. *Smile