Windows 10: after reset pc booting time to much high

after reset pc booting time to much high

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

query about speed of boot time

Hello,

Please be informed that, if there are many startup items on the desktop, it will take time to boot up to the desktop screen. It is the ideal time to boot up.

Also, suggest you to run the system maintenance troubleshooter.

Its a built-in troubleshooter to check and fix issues with system.

Refer these steps:

1. Press Windows key +X, select
Control panel.

2 . Change the view by option on the top right to Large icons.

3. Click on troubleshooting and click on the
view all option on the left panel.

4. Run the System Maintenance troubleshooter.

Do let us know the status of your concern. We will be glad to assist you further.

Thank you.

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.