Windows 10: alienware aurora r12 issue

i just bought this computer a few days ago and i dont feel im getting the performance i should out of it. ive set everything to performance mode. its the intel i7 with rtx 3070. even on performance mode fortnite is only getting 120 frames

:)

 

Alienware says it's Microsoft's problem that my Aurora R3 will not upgrade to Windows 10

I was also having an issue like this, I would follow these steps but I really don't want to dual-boot. Do you think Microsoft (because I know Alienware wont :/ ) will take steps to help us (people with alienware aurora r3's) out? I really like the look of
Windows 10 but to be unsupported without having to perform a little trick on the setup (hold down the power button when the computer is restarting in setup, wait about 10 seconds then start it back up again; basically a manual reboot) is a shame.

https://www.reddit.com/r/Windows10/comments/3f2mvq/upgrade_stuck_on_boot/

This is the post on reddit on the issue, people have had issues with their R3's.

 

Alienware Aurora-R3 & Windows 10

When you have windows 10 installed there is another trick which fixes the fans and makes the Command Center work with my Alienware Aurora R3 when the fans are at 100% and the Command Centre shows no control over fans...

Open your Aurora R3, near the front of the Alienware R3 you will see the SISTER motherboard (smaller than the main) which controls the fans. Unplug the 4 pin power cable with a white thick plastic connector(it may seem stuck and hard to pull out but try
to do it CAREFULLY WITH THE POWER CABLE DISCONNECTED), then power up the Windows 10 Aurora R3 with the sister board unpowered. Then when in windows 10 (the fans should be at 100%), shut down via the software and re-plug the power cable to the Sister motherboard
controlling the fans, enter the Windows 10 again and the fans should be stable and Control Centre should allow you control on the fans either manual or auto.

There was another way I got the fans down from 100% but only recommended as a last resort if you don't want to tamper with the hardware, (it can mess up the operating system and it goes into auto repair where it prompts you to re-install windows 10 - don't
go for the re-install option, restarts and different options fix it always eventually)... you go into sleep mode on windows 10 aurora r3, then when it is in sleep mode power down and power up, the fans MAY normalise, it is hit or miss.

There is also an options in Windows System Admin regarding the fans cannot remember where but you will see it somewhere under power management I think under the Aliwnware FX setting, I cannot remember the proper disable or enable setting that is should be
either it's been so long.

 

Alienware aurora r7 won't start

My aurora doesn't start. It goes to the alienware boot sequence, then it goes to a blue screen saying that windows automatic repair couldn't fix the PC. Is there any way to find what is wrong? The log file it gives me is F:\sources\sos.wim\System32\Logfiles\Srt\SrtTrail.txt

I've tried about any solution I could find, but it keeps coming back to this screen.