Windows 10: an unspecified error occurred 75736e6a726e6c2e

Hi lenovo with windows 11 crashed the first day I bought it with errors local disc C. Tried reset it still crashed with error Local disk. Internet disappeared from computer after starting working again but couldn't log online. Can't even see my network I always log in. Other laptop working on sane WiFi connection. Then done a C f R x in command prompt. Error an unspecified error occurred 75736e6a726e6c2e after stage 4. Sorted few bad clusters with c f r x but that was the end message on command prompt. Internet is gone from laptop so can't go online to download other tools to check hard disk C

:)

 

Unspecified error (75736e6a726e6c2e 500)

Hello everybody,

This thread is closed, but I arrive with a complement to it.

Is anybody able to say anything about error

75736e6a726e6c2e 500

on a disk of 1.81 TB with 1.63 TB free, that was bought brand new less than one and a half years ago ?

 

CHKDSK - an unspecified error occurred (75736e6a726e6c2e 4f6)

Exactly same issue with same error number:

1. Internal SATA Drive

2. I used Windows 7 clean install

-> windows activated

-> Windows 10 media creation tool

-> Upgrade windows 7 to 10 -> keep nothing after upgrade -> install seems fine

-> Run windows update, after drivers installed -> stopped booting correctly and gone into continous loop of bluscreens accompanied by by CRITICAL_PROCESS_DIED

-> run admin console to maybe fix it somehow

-> a LOT of disk errors around, chkdisk finished with error from the screen ("an unspecified error occurred (75736e6a726e6c2e 4f6)")

3. I kept nothing from old Windows7 clean install, but that was no direct windows 10 clean install.

4. yes, this issue happend AFTER I upgraded windows from windows 7 to windows 10

 

Unspecified error (75736e6a726e6c2e 500)

Hello,

Well, it was D: instead of X:, but I did that.

Just a difference in the way to launch it.

I opened a command line window with privilege elevation, and typed the CHKDSK command.

I was prompted that the command could not be operated as the disk was in operation, and was asked whether I wanted to disconnect it. I answered yes. Of course the disk could not be accessed by the system during the operation.

Until the end of phase 4 everything seemed to turn correctly, and I had feedback in French.

When starting phase5, the program stopped after displaying: