Windows 10: Announcing Windows 10 Insider Preview Build 15063 for PC and Mobile

Here you go:




[EDIT]

UUPtoISO used to create the ISO

 

Precisely. I might add that it seems to only add a new 450MB if the new build's recovery environment is different than the current build. This is the first time it's done that here in many builds. But,it has happened before. I'm conscious of it due to the Macrium definitions getting out of kilter...shifted.

Everybody's is a little different, that's just the way it is here.

 

Ok, Cleaned installed in Gen 2 Hyper-V.

 

I have always gotten 1 MSR partition and 1 Recovery partition, every time I clean install, since I started using Windows 10. The sizes vary, but the layout is the same. #1. MSR, #2. C:System, #3 Recovery. This also follows the guideline of creating a recommended partition layout. MS has a lot of topics on this all over the interweb.

EDIT: Creating also a Data partition then it would look like this.

#1 MSR
#2 C: (System)
#3 D: (Data)
#4 Recovery

 

I must confess, I did pass out last night, couldn't stick it out! *Redface

She's all good this morn' though!

 

Have no experience converting UUP to ISO......Kari is our expert in this field, hopefully he might suggest something.

 

Too late now, UUP to ISO should be used before actually going thru with update.

 

If Disk Cleanup has not been done yet, excellent chance it's in Windows.old.

 

Sometimes it's possible to use UUP files in windows.old to make an ISO.

 

Its not me who has a problem, I was replying to Deej post #83 requesting assistance.
See posts #83, 86, 89, 94.

 

I would not count on all files existing in the Windows.old folder. There is always a small chance that some files are deleted during/after the update process. The iso may or may not work, but if for some reason there is a problem after clean installing from ISO created from the Windows.old folders, there is a high probability that at least one file is missing, which can be a disaster for Windows setup. The ISO creation could go smooth despite missing files.

 

Dencal,

no worries, I just thought it may be of interest to the forum. I've reported it thru' Feedback.

To clarify the procedure:

ISO made using UUP, as soon as update had downloaded. Then rebooted to ISO and clean-installed.