Windows 10: Application works in Windows 10 safe mode, but does not work in clear boot

Hello!When I run application in Windows 10 pro with normal boot, it is not responding after few seconds. I tried it in two another PC's with Windows 10, and it works fine.Then I ran it in the safe mode and it works again.Finally I tried to localize issue using clear boot, but it is not responding even with all non-microsoft services disabled and all autorun disabled.Please advise how to find interfering application in this case?

:)

 

Windows 10 is not working even in safe mode

Hi All!
Over the past few days the start menu was not working properly and after trying to fiddle with that for a few days, i decided to reinstall windows 10. The problem with this now is that it boots up properly, but all i get is:




And the only buttons i have are "Networks" and "Ease of access" in the bottom right. Nothing else. The current build i have for W10 is 10240

If anyone could give me some insight on how to fix this i would be forever grateful!
Thanks.
mm

Ps. Safe mode works but i want to be able to run it outside of safe mode without it looking like the picture above.

 

Can't boot into Normal/Safe Mode with Networking, only safe mode...

Good Evening,
I could do with some pointers on resolving an issue. I can only boot into windows in safe mode in Windows 10. Normal mode and safe mode with networking doesn't work. The problem occurred after a windows update. I have removed the latest updates that were installed and cleared any pending ones but it still won't boot properly. I have also run the troubleshooter and tried to recovery to an earlier date which also doesn't work.
The laptop is a HP ENVY 17 notebook. At boot it just gets to the HP logo with the circular loading icon and no further and can only boot it into safe mode. Can anyone recommend the next steps? I have also tried the following;

• stopping startup items
• uninstalling hardware drivers
• removing recent software
• running troubleshooters at boot
• sfc scan
• diagnostic/selective startups with minimal services running

Would the fact that I cant boot into Safe Mode with Networking imply its a network driver related issue?
Bit of a dead end really, any help would be much appreciated
Kind regards
Trevor

 

KVM switch only works in Safe Mode

I don't know if you guys seen it or not, but I posted a thread a few days ago. So I finally got the KVM working...but there's still in issue.

For some reason the KVM only works in Safe Mode. When I do a normal boot the screen goes blank after the Windows 7 splash. I can hear Windows loading, but no video. I booted into Safe Mode and it works fine in safe mode so this eliminates the KVM being the culprit. I suspected it might be the resolution, but it's much lower than the maximum supported resolution.

Any idea?