Windows 10: Asus TUF15 FA506II - Clean installed windows 10 but facing BSoD or system freezing

I just clean install windows10 after I brought but I facing BSoD system_service_exception or system freezing clock stop and mouse, keyboard cannot move randomly anytime only at my house.

Because when I bring my laptop to my office connect router via WIFI, it's seem work fine.

Then I disconnected any connection LAN or Wireless > laptop work fine!!


P.S. 1.This issue didn't appear when playing game connect WIFI.
2. All driver and windows is up to date.

Best Regards,
Nithi P.

:)

 

System freezes at the desktop even after performing clean installation of Windows 10

Hi Peter,

Do not worry we will help you with this issue.

Provide us with additional information to assist you better with this issue:

• Which is the current version of Windows 10 installed on your computer?
• What are the troubleshooting steps you have tried to resolve the issue?
• Were you able to see any error code/ error message when the system freezes?
• Does the same issue persists while booting the system in Safe mode with networking?
• Have you installed all the pending Windows Updates and drivers after performing clean installation?

To identify the issue, try few of the troubleshooting steps below and check if it helps.

Step 1: Now to troubleshoot on it, after the computer boots, I suggest you to check the performance of the system in Safe Mode.

Refer: Start your PC in safe mode in Windows 10


Step 2: Also, I suggest you to test the issue by placing the computer in a Clean Boot state helps in eliminating software conflicts.

Disclaimer: Putting your system in
Clean Boot state helps in identifying if any third party applications or startup items are causing the issue.

You need to follow the steps from the article mentioned below to perform a Clean Boot.

How to perform a clean boot in Windows

Note: After troubleshooting, refer to the section “How to reset the computer to start as usual after troubleshooting with
Clean Boot” to return the computer to a
Normal startup mode.

Step 3: Follow the below steps to
place the computer in normal mode.

• Press Windows + R keys to open Run
  command.
• Type msconfig and press Enter.
• In the System Configuration window, click on
  General tab.
• Select Start-up selection as Normal startup, click on
  Apply and Ok.
• Follow onscreen instructions.

Hope it helps. Get back to us with an updated status of system freeze after reboot for further assistance.

Thank you.

 

Is it time for Windows 10 already?

Here's a good step by step guide on doing a fresh install.

How to clean install Windows 10 from a USB drive - Software - Feature - HEXUS.net

 

Clean Install Workaround for Vista

You may remember this news story on techPowerUp! a couple of days ago relating to the lack of clean installs when using the Upgrade Editions of Vista, which required an old OS to be installed. However, Paul Thurrott has managed to find a workaround for this issue, which ironically lets users do a clean install Vista without any previous version of Windows, albeit a little tedious. Here are the steps:

• Boot from the Windows Vista Upgrade DVD as normal
• When prompted for a product code, leave this blank
• Select the version of Vista you have purchased and let Vista install
• When you boot to your desktop for the first time, run the Vista setup from Windows
• This time enter your product key
• When asked whether you want to do an Upgrade of Custom install, select custom and choose a clean install
• Windows will now install for a second time and you should be able to activate it

Remember, these steps are only advised for use in order to achieve a clean install of Vista, it is only legal to use the upgrade editions if you have previously purchased the appropriate version of Windows.

Source: DailyTech