Windows 10: Attempting to Reset PC, it goes straight to BSOD w/ code "System thread exception not handled"

Attempting to Reset PC and remove everything with a clean windows installation. After making the selections with the "Reset this PC" tool, the PC restarts and it goes straight to BSOD w/ code "System thread exception not handled". The PC then boots back up normally and the "Reset this PC" tool says that something went wrong and the reset was cancelled. I did some research and saw somewhere it could be an issue with the windows backup image. So i created a new recovery drive via a USB stick and tried to boot into that by changing the boot sequence from the BIOS menu. I again got the same error

:)

 

"SYSTEM THREAD EXCEPTION NOT HANDLED" BSoD

My PC is stuck in a restart loop with a BSoD that states "Stop Code: SYSTEM THREAD EXCEPTION NOT HANDLED".

I can't even get into Automatic Repair and the BSoD even showed up when I tried to do a clean install from an ISO, the moment it boots up i get the BSoD without being able to do anything.

 

system thread exception not handled / ntfs.sys

Hey, thanks again for the reply!

Please check my 2nd bullet point, with the 2 notes.

-----------

• W10 1809 media creation tool - boots but results in the same error.

1. Note 1: if I disconnect SSD1, HDD1 (W10 drive systems) the W10 USB can boot!
2. Note 2: while using W10 USB, If I attempt to reconnect either drive I get BSOD (system thread exception not handled - ntfs.sys)

 

Stop Code: SYSTEM THREAD EXCEPTION NOT HANDLED

In case you haven't resolved the problem yet, here is what I found:

rtsuvc.sys

Realtek UVC webcam Driver

OEM Only - go to system manufacturer's support site

None at: http://www.realtek.com.tw/downloads/

It seems something goes wrong with this driver. I would suggest reinstalling it to fix the problem.

Here are a few other solutions you may try:

Cara Memperbaiki Kesalahan Pengecualian Thread Sistem yang Tidak Ditangani -