Windows 10: audo breaks almost every time i join a call

almost any time in a scenario where my mic is used, such as a discord call, my audio completely glitches out. it starts to completely stutter the last sound that played and i cant hear anything else, i have to reset my computer for it to stop, ive recently downloaded new graphics drivers, and im assuming that might be messing it up because i have never had this problem beforehand.

:)

 

Windows 10 Pro and Ergnomic Break Reminder

Hi,



Apologies for the late reply.



Do you remember installing any break reminder software?



It looks like it is a pop up from a break reminder software.



I suggest you to look for this in Programs in features and uninstall it if do not use it.



Try the following steps:

• 
  Press Windows + R keys to open Run Command
  
• 
  Type Appwiz.cpl and hit enter
  
• 
  Search for the programs and un-install it.
  

Regards,

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

UnattendedJoin error: failed to find the domain data (0x6e)

Thanks for the suggestion! I don't want to add a domain account, as this is a generic unattended install that will be used for all company machines. Do you think it's possible that the computer would join the domain if, instead of using UnattendedJoin in specialize, I used your steps but left out the specific account? The other thing I was thinking was to use a generic account to allow the domain join during the specialize step. I added a machine password in the UnattendedJoin component, and instead of getting the error listed above, I got an authentication error, which makes me think I could probably do a secure join instead of the unsecure join. Thoughts?