Windows 10: automatic scan disk on restart

Automatic scan disk at every restart during recovery session and in normal use. If not stopped within 10 seconds a two hour scan disk follows

:)

 

Disk management console view is not up-to-date

i dont know how to fix your disk management, but i can fix your partition problems...




open up Command Prompt with admin rights. (Right click, run as admin)


enter in
DISKPART
list disk

then find the Disk number for your Raid array... lets call it number 7 ( you can tell what disk is what by the total size)
type in

Select Disk 7
List Partition (will give you a list of all the partitions..)
Select Partition 1 (im assuming you only have 1 partition on Disk 7) repeat this step if you have more partitions.
ASSIGN


that should get the array up and running ready to use.


EDITED.

any problems, post back ^^


Still EDITING *Stick Out Tongue

side question, have you tried restarting the PC?

 

How to disable Windows Defender 'Health Scan'?

Normally the first thing to suspect with random restarts would be hardware.

Suggest you do a RAM check (see Tutorial section for a guide if unsure).
You have 16Gb- are all sticks identical?

Check your disk(s) e.g. Hard disk sentinel (trial) - if ok
Do the chkdsk scan as above
If ok from an admin command prompt run
SFC /SCANNOW
and post the summary result.

Check your Reliability History and explore red x's.

Try changing the setting as in Step 1 Disabling the automatic restart option to view error messages here:
HP PCs - The Computer Restarts Unexpectedly (Windows 10, 8) | HP® Customer Support

 

Automatic Restart

We appreciate your response. We suggest that you turn on the automatic restart using command prompt. However, you need to access the
Startup settings. On some Windows 10 computer, pressing
F11 once a computer boots up will bring the System Recovery menu. We suggest that you check if it's the same on your computer. Here are the steps on how to do so:

• Turn on your computer, then press F11 simultaneously.
• If a blue screen with Choose an option shows up, click on
  Troubleshoot.
• Look for Advanced options, then click on Command Prompt.
• On the command prompt, type this in "wmic RecoverOS set AutoReboot = True".
• Once done, click the "X" at the top right of the screen.

Restart your computer and see if the issue persists.

We would appreciate it if you'd provide a screenshot of the command prompt.

We're looking forward to your feedback.