Windows 10: Backspace writing numbers

Hello!


I came across weird thing on my pc. It happened out of nowhere. When I start typing it usually out character "`" in front of a sentence then when I hit backspace quickly it writes "§123"

When I press it firmly it writes "§1234567890+"

When I press shift+backspace it writes symbols like ()!?


Other than that it works fine.


Can you help me with this issue

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Why does my Enter and Backspace act weirdly?

• #1

I have an Asus X540-YA laptop, and sometimes when I press the Backspace, instead of deleting the character, it writes down the combination of "74321", and sometimes some dots as well. Same thing with my Enter, sometimes it just types "nbz" instead of jumping
a line when typing. I have tried to restore my Windows 10 the the original settings and re-install a driver ASUS sent me, but it did not help. Any suggestions what could cause it, or what could I do?

 

Holding down the backspace is much slower than usual

Hi Chris,



Thank you for posting on Microsoft Community. We will assist you in resolving the issue.



Before assisting further, I would like to ask few questions:

• Does the issue persist when you press Backspace key in all programs?
• Does the issue persist with other keys on the keyboard?

Step 1: It may be due to the reason that the PC is infected with
Virus/Malware. I suggest you to run the anti-virus software that is installed on your PC and check if the issue is resolved



Step 2: If the issue persist, run the Hardware and Devices troubleshooter by following the steps below and check if the issue is resolved.

• Type Troubleshooting in the search box next to
  Start button and select the top most search result.
• Click on View all from left side panel of the screen.
• Select Hardware and Devices, click on
  Advanced option and check Apply repairs automatically
  option.
• Follow the on screen instructions.
• Close the window and check if the changes are effective.

Write back to us with the answers to the above questions to assist you further on this query. Your reply is most important for us to ensure we assist you accordingly.



Thank you.