Windows 10: battery will not charge

HP G62 laptop. Battery went completely dead and will not charge when plugged in. says" plugged in not charging"

:)

 

New battery not charging


I have an Acer Aspire V3-771 laptop (which is three and a half years old) with its original battery. As the battery is not holding the charge for as long as it used to I decided to replace it. I inserted he new battery, which already showed a charge of 60%, and let it run down to the point when the laptop turned itself off. However, when I tried to recharge the battery, the battery icon showed "6% available, plugged in, not charging". I contacted the supplier of the battery and they sent me a new one. This showed an initial charge of 93% so, in view of my problem with the previous battery, I decided to try and charge it up to full capacity before letting it run down. But as soon as I tried this the battery icon showed "93% available, plugged in, not charging". So I unplugged the charger and again let the battery run down until the computer turned itself off. I plugged the charger in again but then got "6% available, plugged in, not charging". I have no problem charging the old battery, so can anyone please suggest what the problem might be? I have tried taking out the battery and unplugging the charger and holding down the power button for 30 seconds, but this hasn't worked. Grateful for any advice.

 

Battery won't charge to 100%, even though it says it did


The Sm@rtA$$ suggestion would be to replace the battery *Wink and to be totally honest that is the only surefire solution, Batteries have a usage life as well as a shelf life (which can mean that if a battery is stocked for a long time before first use you could already be part way down the road to failure.

There are methods to condition some older types of battery (NiCad), which tends to build up a charge memory if the users charges the battery too much - Ni-Cad batteries should be allowed to run down to almost no charge regularly to prevent this and following a similar but exaggerated system can work to reverse the issue -


Ni-Cad Conditioning

• Fully charge the battery
• Leave the device running at a high load, [Playing Video / music / encoding a video, (that you can afford to lose], after you switch off all battery saving options so that you can actually get to a situation that the battery gets so low that the device shuts down - leave for half an hour and try again as sometime the battery can "regain" access to more power reserve
• Fully Charge the battery
• Repeat This several times and also perform this action Once at least once a month

NImH batteries are supposedly immune to these issues but it can sometimes happen and the above routine may help but is just as likely to not do anything



The basic issue here is that a battery is a chemical reaction based device and the chemical reaction is reversible, (charging) only a set number of times ( you will often see very small print on rechargeable batteries stating an approximate number of charge cycles possible), the problem is that switching the device on when plugged into the mains supply is treated by the battery as a charge cycle. Some laptops will allow you to remove the battery and use it as a normal mains device - some will not - if you have to have the battery in place to use the laptop then don't plug it in if you can as this will actually improve overall battery life, both per charge and over the full life of the battery

 

battery charge bug


cheers mate, ive just treid that , my battery was fully charged so will see what happens when its down to around 9% and i plug in the charger...odd thing is i noted the driver for this application to be dated 20-06-2013, after deleting/unistalling it reinsatlled drivers dated 21-06-2006...tried to update but says i have latest installed...will wait to see what happens..ta


ok update, tried what was suggested but didnt work...still shows same message when plugged in to charge battery..