Windows 10: BCD error

Hello everyone,

I got a message “Restart to repair drive errors” notification from Security and maintenance. I had got this notification several times, so I clicked it this time so that it won’t show it again. I clicked on it, and clicked “Restart now”. While the spinning dots appeared, the OS crashed and gave me the error “Your PC couldn’t start after multiple tries and needs to be repaired”. I pressed F1 to enter WinRE and while trying to boot in it it showed the error “The Boot Configuration Data doesn’t contain valid information for an operating system. Is this a bug or there was a warning about this?

Help please.

PS: The OS never booted after this error.

:)

 

Error code 0xc000000f, BCD corrupted

Hi Andre,

As per the description, I suggest that you follow the steps below to fix BCD

1. Right click on the Start Menu and select Command Prompt (Admin)

2. Here type/paste the commands listed below

Bootrec /fixMBR

Bootrec /fixBoot

Bootrec /RebuildBcd

3. Once done restart the PC and check.

Hope this helps

 

Windows defender offline error: EFI\Microsoft\Boot\BCD - 0xc0000185

Hi Dave,

Could you provide us additional information to assist you better with this issue:

• What is the make and model of your device?
• Have you made any changes to the operating system prior to this issue?
• Are you able to boot the device to desktop with this error message?

This issue might have occurred due to corruption in the boot files or BOIS unable to detect your drive to boot.

I suggest you to refer to the below thread, check if your issue matches with the same.

If so, try the troubleshooting steps suggested by -.[Final]#[Boss].- and check if
it helps.

Error code after update File:\EFI\Microsoft\Boot BCD
Error Code 0xc0000185 BSOD

Hope this information is helpful.

 

How to clean up BCD entries? Rebuild the BCD?

This is normal that under Recovery Environment, The letters are re-assigned. This is why you have to be careful and select the correct one.
@dictum
Advice: Never use Easy BCD with Windows installed using GPT disk. Use Easy UEFI instead provided you know what you are doing. Easy BCD only works with MBR disk type.
Base on the screen shot above. Your disk 0 is your new Windows and your disk 1 contains the old Windows. Disk 3 contains a 512MB Fat32 partition and I don't know what that is. I suggest you disconnect disk 3 for now before proceeding.

Let rebuild new BCD's for both disk 0, and disk 1. Please follow step by step on the 2 screen shots below. On step 3, write down the drive letter for PM981_New. In the screen shot, My Windows is still assigned to C but it might be different from yours. In step 10, if the drive letter is different than C, then use the letter in step 3.

Do exactly the same for disk 1, this time select disk 1 in step 4 and assign letter V in step 7, Use V and the drive letter for Old Windows in step 10. This will create a new BCD for PM981_Old and you will be able to boot separately from boot menu.

From boot menu, select which one to boot from.
Once booted into Windows. If you wish, you can set up dual boot for Windows old & New. Under This PC, look for the drive letter of the offline Windows and type:
bcdboot X:\Windows where X is the letter of the offline Windows