Windows 10: Bios boot loop after cleaning ssd

I have 2 installations of windows on my pc and have been trying to remove the one from my SSD. so i went into cmd in troubleshoot upon startup of the pc. i typed diskpart , list disks, select disk 0. clean. and it successfully cleaned my ssd. now my pc keeps booting up my bios and i cant get it to boot.

:)

 

My m.2 ssd is recognized in bios, but not as a boot device

Thank you very much for reaching out! As an Independent Advisor and fellow Microsoft user, I'm more than happy to assist you.

Here are some steps you can take to troubleshoot and potentially resolve this issue:

1. Check BIOS Settings

Ensure that your BIOS settings are correctly configured to recognize the M.2 SSD as a boot device:

• Enable CSM (Compatibility Support Module): Sometimes, enabling CSM can help the BIOS recognize the SSD as a boot device. You can find this option under the Boot tab in the BIOS settings.
  
• Set Boot Priority: Make sure the M.2 SSD is set as the first boot device in the boot priority list.
  

2. Update BIOS

Updating your motherboard's BIOS to the latest version can resolve compatibility issues with new hardware:

• Visit the ASUS official website to download the latest BIOS update for your ROG Strix B650 Wi-Fi motherboard.
  

3. Reinstall the SSD

Ensure that the M.2 SSD is properly installed:

• Remove the SSD and reinsert it firmly into the M.2 slot. Make sure it is securely fastened with the screw.
  

4. Initialize the SSD

If the SSD is new, it might need to be initialized:

• Boot into Windows using another drive, open Disk Management, and initialize the SSD as either MBR or GPT.
  

5. Check for Drive Mode Compatibility

Ensure that the M.2 slot you are using supports the type of SSD you have (SATA vs. NVMe):

• Some M.2 slots only support either SATA or NVMe, not both. Refer to your motherboard manual to confirm compatibility.
  

6. Repair Boot Configuration

If the SSD has Windows installed but is not recognized as a boot device, you might need to repair the boot configuration:

• Boot from a Windows installation USB, go to the command prompt, and use the following commands:
  
  
  This can help rebuild the boot configuration data.
  

7. Check for Hardware Issues

If none of the above steps work, there might be a hardware issue with the SSD or the motherboard:

• Test the SSD in another system to see if it is recognized as a boot device.
  
• If the SSD works in another system, the issue might be with the motherboard. Consider contacting ASUS support for further assistance.
  

Please feel free to reach out if you require any additional assistance. I'm here to help!

 

BIOS stuck in a loop.

Hello,

We would like to ask some additional information to better isolate the issue:

• Did you get any error messages?
• Have you tried to boot in Safe mode?

We suggest that you check the solutions provided on the links below:

BIOS-loop

Stuck-in-BIOS-loop

We will wait for your response.

 

HP Laptop Boot Loop

I am encountering a boot loop problem with my HP laptop. Upon startup, it shows the HP logo and loading dots for about 11 seconds, then goes to a blank screen for approximately a minute before automatically restarting. The power button does not turn off during this cycle.

Troubleshooting Steps Taken:

• Tried hard reset and accessing BIOS/UEFI settings.
  
• Unable to boot into Safe Mode or recovery environment.
  

please see here the recorded video demonstrating the boot loop behavior for reference.

Any advice, troubleshooting steps, or insights into what might be causing this problem would be greatly appreciated.

Thank you in advance for your help and suggestions.