Windows 10: Bitlocker on startup in Windows 11

Ever since a failed recovery from backup, Windows 11 presents the Bitlocker screen whenever it starts up. I have the recovery key, and I can enter that to continue. How can I no longer have to enter the recovery key? I can appreciate what Bitlocker is there for, and would rather not disable it.

:)

 

Can't get GPU-Z to start with Windows 8.1 startup

I'm not sure how to do that. Could you list the steps for a noob?

 

Bitlocker locked on startup

Hi,

Thank you for posting your query on Microsoft Community.

Follow the below steps and check if it helps:

I suggest you to try the step under the section "To unlock removable data drive" in the following article:

Windows help & learning

Note: The steps for Windows 8.1 applies to Windows 10 as well.

For further reference, ask OP to refer to the following article:

Windows help & learning

I hope this information helps.

Thank you.

 

BitLocker won't enable on Windows 10 after update on Aug 9

Hi Brenda,

I would be happy to assist you.

Before I assist you I would like to know the information below,

• 
  Do you have a Windows 10 copy of the operating system?
  

I suggest you check whether the Bit locker is ON or OFF using the steps below.

Can you verify if BitLocker is enabled or disabled on your device? You can Enable/disable BitLocker by going to Desktop and follow these steps:

• 
  Swipe Right to Left to bring up the Charm.
  
• 
  Choose Settings.
  
• 
  Choose Control Panel.
  
• 
  Select BitLocker Drive Encryption.
  
• 
  Verify whether BitLocker is on or off on each device.
  

Also I suggest you to enable the WinRE so that you can enter the bit locker key and proceed.

When WinRE is disabled, you cannot enable BitLocker, and you receive an error message that resembles the following.

This PC doesn't support entering a BitLocker recovery password during startup. Ask your administrator to configure Windows Recovery Environment so that you can use BitLocker.

The solution would be to manually enable the windows recovery environment:

• 
  Copying the winre.wim file from c:\windows\system32\recovery\ to a folder on a recovery partition. (The partition need to have a drive letter at this point.)
  
• 
  Set the RE Image path. Example: reagentc /setreimage /path r:\recovery\windowsre
  
• 
  Enable RE with command: reagentc /enable
  
• 
  (You may remove the drive letter for the recovery partition after you have done this.)
  
• 
  Bit locker will be enabled.
  

If the issue still persists, suggest you to post your query on the below link.

https://technet.microsoft.com/en-us/library/hh831507(v=ws.11).aspx

Hope this information was helpful and do let us know if you need further assistance. We will be glad to assist.

Thank you.