Windows 10: Bitlocker password failed after Reset

I reset my Windows 11 yesterday to free storage space taken up by various caches. When that's done, I can access D: drive. I noticed that the Bitlocker had been turned off during reset, so I right-click D: drive and re-enable it back.Today, after the computer restarts, the D: drive is locked by BitLocker and I can't unlock it. I have tried all passwords I know and used both the recovery password I saved and the recovery password saved in microsoft.com tied to my account.It seems after reset, the recovery password changed and I can't unlock the drive at all. Any help would be greatly appreciate

:)

 

How to reset Windwos 8 Password?

Change or reset your Windows password - Microsoft Support

• If you've forgotten your Windows password, there are several ways to retrieve or reset it:
  • If your PC is on a domain, your system administrator must reset your password.
  • If you're using a Microsoft account, you can reset your password online. ...
  • If you're using a local account, use your password hint as a reminder.

 

why doesn't my bitlocker make me type a password?

Hi,

I understand that you have issue with Bitlocker password. I will certainly assist you with this.

Please provide us below details for better assistance,

• 
  Is your Bitlocker enabled on your system?
  
• 
  Have you made any changes on your system before this issue?
  

Please follow these steps and check if that helps.

Method 1: I suggest you to start the BitLocker Device Encryption service.

Follow the below steps:

1. Press Windows key + R from the Keyboard.

2. Type services.msc and hit Enter.

3. Search for BitLocker Device Encryption service.

4. Double click on BitLocker Device Encryption service and click on Start button.

5. Click on the dropdown list and set the Startup type to Automatic.

If the issue persists then change the password and change the settings on how drive is unlocked at startup.



Hope it will fix your issue. Please let us know the status of your issue.

Thank You.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".