Windows 10: Bitlocker+Unable to factory reset+Boot device not found?

Hello, I am having a few problems occurring at the same time and seriously need some help. I will list out the problem one by one below.1 it was about 2 days ago, my computer had a bitlocker lockdown, and i went into my microsoft account to find my recover key. however, the key seem to be dated around in May yet the tag stated on the computer is in October.... that was my first problem.So then i thought i had a backup and decide to factory reset this thing..... which caused my second problem.2 I try click reset through cloud or online, however it was called [it was in other language than eng

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

How to skip Bitlocker Recover Key Screen in Factory Reset

I have deleted a device from AAD, and now am unable to do a factory reset because I can't get past the Bitlocker Recover screen. I don't need to be able to access data. I am trying to reset it to factory for someone outside of the company to use. Is there any way to get past this screen? It has been deleted from AAD so I no longer have the recover key.

 

Ive factory reset my computer but I can't use the mouse or the keyboard to select laugage

Hi,

A device like your keyboard and mouse is not detected during factory reset.
To help us determine the appropriate troubleshooting steps
that can resolve your concern, we would like to ask the following questions:

• Are you performing a factory reset on a laptop or a desktop?
• Is this the first time you perform a factory reset on your device?
• What troubleshooting steps have you done so far to resolve your concern?

In the meantime, if you're working on a desktop, we suggest that you try to use a PS2 keyboard just to bypass the installation process. Once Windows is up and running, you may now plug your mouse and keyboard to initialize Windows to detect these devices.

We look forward to your response.