Windows 10: Black screen after ' preparing automatic repair '

Please help me, i was using my pc normally and a pop up came from 'sequrity and maintenance' like, 'reboot to start repairing disk'...I don't know, I don't remember that.But after i clicked on restart restarting screen was showing for like 10 minutes, so I pressed the power button for some seconds. And the trued to boot, after some time it showed me this messageAfter that i clicked on continue windows logo was showing for so long, so i pressed the power button again and then it showed preparing automatic repair after that my screen always goes black but I can move my cursor. please help me

:)

 

Black screen after ‘preparing automatic repair.’

Thank you very much for the reply. Unfortunately, I don’t know if it’s my doing something wrong, but I’ll do the steps to boot up the ASO menu and it won’t appear. I’ll reboot three times and leave it to load at the third, but it will do the same as before except for one thing- load for a while, then seemingly reboot on its own quickly (which it didn’t do before the ASO reboots), before going directly into ‘preparing automatic repair’ followed by the black screen shortly after. Same as before, leaving the black screen alone won’t do anything.

 

computer screen turns black after it shows preparing automatic repair

it shows that for about 5 seconds and then the screen turns black With a white foggy bit

 

Black Screen after "preparing automatic repair"

Yesterday, my HP Envy 17 j177nr was working flawlessly. However, today I was experiencing lots of lags and freezes to the point where the laptop is unusable

I decided to power off and on three times to attempt some kind of repair. However, after it says "preparing automatic repair" I ALWAYS get a black screen, no cursor, no nothing. It does NOT move beyond that black screen. It will stay at that black screen all day if I let it.

I tried ALL steps on the internet to fix it, including removing all peripherals including the power cord and battery and holding the power button for 30 second which everybody says that fixes the problem—except it DOES NOT for me. It still goes into "preparing automatic repair" and to that black screen afterwards.

I ran the HP HDD and memory test and all pass with flying colors.

Does anybody know how to fix this?