Windows 10: Blank Screen after Formatting Hard Disk

Hi,I wanted to install a fresh copy of windows on my laptop. After inserting the installation media and going to the installation menu, I used diskpart in command prompt clean my drive. Then I restarted my laptop but now no display shows up. I cannot access the bios settings or boot menu. But the laptop is on because I can hear the fan noise. I cannot go to the installation screen even though my installation media is inserted. Please help.Laptop: HP 15s-du1030TX

:)

 

How to format a hard disk correctly?

I hope the specs I included are enough if something is missing, tell me and here is a screen:

- - - Updated - - -

Do you think the problem would disappear if I just format my hard disk?

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Formatting Hard Disks

We advise posting your query on a Linux support forum to receive proper instructions on how to format your spare hard disk. The support agents of the Linux support page should be able to provide you with the detailed steps on how to format a Linux hard disk.

If you have other questions or concerns in the future, we're just a click away.