Windows 10: Blue screen after netsh winsock reset catalog

I was having some internet problems for a while and noticed „Media disconnected” status on ipconfig. I googled it and a website told me to rum these commands on administrator cmd:netsh winsock reset catalognetsh int ipv4 reset reset.lognetsh int ipv6 reset reset.logAfter restarting my device blue screen opened and I can’t fix it.

:)

 

How to reset whole netsh? (Windows 7)

Was wondering has the commands changed somehow since on Windows XP and on Windows Vista 'NETSH INT RESET ALL' cleaned entire netsh up from top to bottom.

Now on Windows 7 this same command says no go and only way I can see it is by building .cmd/.bat which does something like:

Code: netsh winsock reset all netsh int 6to4 reset all netsh int ipv4 reset all netsh int ipv6 reset all netsh int httpstunnel reset all netsh int isatap reset all netsh int portproxy reset all netsh int tcp reset all netsh int teredo reset all[/quote] now the king of the hill of bugs is this doesn't actually do even it's job even after reboot. values setup to are not reset to defaults. (I know I could add more entire list of entries there is, but looking for clean delete/wipe settings & default everything not to dump entire list of resets.)

So, anyone got a plan B?

 

netsh winsock reset

Hi,

Wonder if anyone can assist.

Have been using a 3 network dongle for a few years and had no problem. But the last time that tried to top-up the dongle to use the it kept getting - error 619 -

Did a search and found - netsh winsock reset; followed the instructions below and received a message that the command had been successful and the computer needed to be rebooted. Did that and when the dongle was attached got error 619; port closed.

Tried this a couple of times, removed the 3 network and reloaded, turned off the fire-wall; nothing but port closed.

Does anyone have any suggestions?

Thanks in advance.

1. Press “Windows key”, start typing “command prompt” on the start screen.

2. “Command Prompt” will appear in the list, now “Right click” on command prompt.

3. Click on “Run as administrator”, if you get a UAC prompt click on “Yes”.

4. Now type the command “netsh winsock reset”, press “Enter”.

 

Can’t connect to internet after winsock reset

No internet access after winsock reset..
I’m on Windows 10.

Long story short an online game wasn’t working for me so I followed a Youtube video that told me to enter in some commands in cmd. Commands were:
netsh winsock reset
netsh winsock reset catalog
netsh int ipv4 reset

I reset my laptop and now I can’t access the internet..

I tried again with another set of winsock reset commands but still doesn’t work. Help?